I've about got all the wires sourced. I might give it another shot. I don't know, I'd almost rather work a couple days over time and let someone else do it lol.
So today I put some of my front end back on. I had everything powder coated. I almost took the control arms apart and had them powder coated as well but the bushings were tight and I didn't wanna take a chance on screwing them up. Instead I got some Eagle One MAG wheel cleaner and a non-scratch scotch bright pad and they cleaned up nicely, almost new looking. I've done this before on my daily. After the initial deep cleaning every time I wash the car I just spray the MAG wheel cleaner on the control arms and such and the grime sprays right off. (Eagle One should pay me for that lol).
Since the front end was going together smoothly I decided to work on the battery some, here's a better idea on how its going to sit. I had to trim some because of the anti-roll bar but this is about how it'll look, but covered and sitting about an inch lower in the chassis. I may have got a little happy with the cut off wheel and cut too much off. but I have a couple ideas on how to clean it back up.
