Dyno results bone stock LQ4/T56 Rx7

[nick Ritter]

motor is on a stock tune 2007 chevy express LQ4, 2002 camaro T56 ss trans
CIA and aluminum flywheel are the only things that would potentially net power
pull was done in 4th gear on 4:10s
28.7 in loaded tire diameter
mustang dyno set to read on inertia not load so pretty much is a dyno jet
i was supposed to be testing for emissions/economy couldn't figure out how to get the graphs up/priinted
if anyone is interested in the  emissions/economy i will post them up still working on some of it

any questions ? ask away

if someone could tell me how to get pics full size in the thread that would be awesome

[nick Ritter]

  better video of the 1/4 mile run i did

[digitalsolo]

Nice numbers, not too crazy, good intake and exhaust make a big difference.

[DDv8]

if someone could tell me how to get pics full size in the thread that would be awesome

Try making the pictures   800 by 600  mine usually show up full screen

DD

[nick Ritter]

Nice numbers, not too crazy, good intake and exhaust make a big difference.

i have ls3 heads on thinking about putting on with supporting mods or keep the 317s and boost them. i still have yet to decide i just love the drivability of NA

[nick Ritter]

if someone could tell me how to get pics full size in the thread that would be awesome

Try making the pictures   800 by 600  mine usually show up full screen

DD

how do i go about doing this?

[nick Ritter]

if anyone is interested in throwing their car on the dyno near mankato mn. i have full access PM me if interested

[DDv8]

if someone could tell me how to get pics full size in the thread that would be awesome

Try making the pictures   800 by 600  mine usually show up full screen

DD

how do i go about doing this?

Resize them with a photo editor.

DD

[nick Ritter]

[attachimg=1]

[LQ4whore]

Great numbers for bone stock, have a similar setup 2004 LQ4 with a 2002 LS6 Cam and Intake with Poorboys and ended up with 322 HP and 315 lbs to the wheels. I had a couple guys ripping me for that being low but what do you expect with 8.5 to 1 comp NA motor.

[nick Ritter]

I now got the following

2007 lq4 bone stock

BTR stage 4 cam with valve train support
Professional products intake ported to 102mm
Nick williams 102mm TB
Sanderson headers
E85
dyno tuned


put down 400/400 on a mustang dyno !!! peak power was about 6200 torque came on hard at 4k spinning the stock bottom end to 7300RPM

I will post the graph soon

[largeorangefont]

Nice!

[shainiac]

I now got the following

2007 lq4 bone stock

BTR stage 4 cam with valve train support
Professional products intake ported to 102mm
Nick williams 102mm TB
Sanderson headers
E85
dyno tuned


put down 400/400 on a mustang dyno !!! peak power was about 6200 torque came on hard at 4k spinning the stock bottom end to 7300RPM

I will post the graph soon

Good numbers, especially for a Mustang dyno. Are you still using stock 317 heads?

[nick Ritter]

yes bone stock long block gen 4 rods etc